It sounds like your Y axis is jogging. Did you adjust every axis as the manual indicates? I would remove the floor and run the program again so you...

Jan, could you post a video of the issue? Let us see what's going on.

I use UCCNC, but your software also works with it. It's very easy to work with.

I use this: CAD: Qcad CAM: V-Carve/Aspire It works for me.

I've found a bug in my macro and I've fixed it. Now it should work properly with any probe height. M31_2015-10-08.txt

Ah, I see, then yes, that sticky pad would be good. From what I see on youtube, people use duct tape, even on big machines. Just try it before e...

Why not simple duct tape on all 4 sides?

just like I thought .. There comes a dumb ass .. that knows to copy paste. So how do we make this codes happen in WinNC-pc? off course you don't k...

blanthegenius.. would it be possible to tell us more on how to output a signal for only on/off of the laser connected to relay 1+ gnd wire.... ? I ...

When the smoke came out of my steppy 🙁 I was measuring to find out how many volts can I get on the Pin7(found on forum that this is the Spindle PWM ...

I don't know a lot about metals but from what I've read, aluminum has lots of variants/alloys. While one can be soft to machine like plastic, other...

yes for sure 🙂 there are many ways of doing it - will test that one you have modified when time allows. thanks for the input. Hi, I've written a p...