Does anyone the Stepcraft install USB for version 1.2026? I only have the install USB for version 1.1027. Do you mean updating the UC100? It will a...

Remember there is an official Hot wire cutter too:

Tried with a flame but still not transparent. I might look at acrilic end mills.

Latest version is 1.2026 Download and install it:

Wow! good job! One question: Is this material melamine? If yes, which tool did you use in order to have this clean cut? Thanks, Javier It...

What about contact adhesive? It's easy to remove with your fingers by rubbing it.

Too much work for an easy task IMHO. You're exchanging double tape for homemade double tape. I don't see the benefits at all. I just screw the piec...

Can you post a video with the issue, on youtube for example?

I also ran into this problem. Solution: level the board with a 20mm end mill. This will set your height uniformly across the board. After that, ...

Hi Joe, welcome!. I look forward to see your projects posted in the forum 😉

It would have been easier to buy a cheap Powered USB HUB and use it as a simple repeater, connecting both the UC100 and your PC to it.

Do a multi pass program. If your total depth is 1mm, try a first pass at 0.8 and a last pass of 0.2mm. That should help. Also try different feed sp...