Last seen: Apr. 29, 2018
Thank you Alan, I'll give it a try 😉 [edit] Damn, shipping costs are high for a single nut. I'll have to invent something :unsure:
the only thing I dislike about the stepcraft is not having twin Y-axis motors. I hate belts with all my heart.
Put the UCCNC in Offline mode and run the program. You can skip lines to the part where it usually fail. See if it fails. Check the gcode when it f...
I think your spindle is not 100% perpendicular to the table.
Yep, I also had to sand the baseplate borders because it was impossible to slide in. Bad design is bad.
Bienvenido! B)
are the rollers are too tight?
AFAIK that postprocessor must be an alias for mach3. Are there any differences?
There is an option in each axis configuration tab for reversing them. Try it.
Do you have a license code or file for UCCNC? If so, download the latest version from the developer. Then put that file on the uccnc folder. Finall...
post pictures or a video of the issue, to try to help you.
Try asking stepcraft stuff about that. But I use the non-stepcraft version just fine.