Last seen: Mrz 23, 2021
Hy MagIO2, my usual cutting depth for POM is 0.5 mm for a 6mm dia tool (0.4 mm for 1/8"=3.175mm endmill, since it is less rigid). The feed rate for...
Hello MagIO2! I would say that, in any case, 2-flutes or 1-flute (6mm or 3.172mm or 1.5mm) end-mills cuts POM like a charm! No problem about that b...
Hi Nick, I think that the most difficult thing is... the technical jargon. When I started I had no idea at all of what a simple sentence like "jogg...
Ok, so I think that I will abandon my idea about cutting rubber. Anyway I've discovered something new about usage of the routers as cutters. The i...
I suspect that the steps I wrote are not completely correct. When the cutter is lifted up in A a little amount of material in the corner remains uncut...
The description of the SC dragknife reports: "angular degree: 60, suitable for foils over 0,5 mm" But it's not clear if 1.5 mm of rubber can be cut o...
Single flute End-Mill fully promoted! 🙂 🙂 🙂 Rory was right, another life with a single flue on POM-C material. Vibrations are reduced of 50...
Here I think payment is due end of the month. No, if you have a SHUFA certification and you work in Germany then you can have a credit for the period...
looking forward to seeing the results. I think you will get much better results. The results on our larger router are much much better... but not sure...
Endlich! The vise fro CNC-plus.de has arrived (they was in holidays)! Soon I will report here my impressions.