Danke Chris! No time to check pin 17 today, I'm going to verify it tomorrow. Anyway definitely seems that I need to configure/use an additional pi...

Ubrigens, also in "Manual" mode I cannot make the HF500 spindle turning on (i.e. by clicking the "" buttons on the TkLinuxCNC GUI interface) 🙁

Please refer to this Thread for screenshots on the setup of the axis. Note the position of the switch as a negative value on the x-axis. On the y and ...

Well, you're right. Moving just one axis a time and waiting for the switch can be used to set a reference point. Do you want to laugh? With linuxCNC ...

but is it possible is the question therefore that the 3 switches are somehow serial... yes, now I realized that those 3 switches are linked together ...

Hello, actually, after that I wrote the post above I've googled for a while and I've discovered a lot of guys having no problems even using on-boar...

@Aldronaigh about LinuxCNC control software: I heard that you need a very good graphic card for your PC in order to use it. It is true?

We can cut this for you. You have a PM

Here are my 2 cents again 😉 ................ I think that I've got perfectly your ideas MagIO2.... mmmmh... sehr interessant... I have to thin...

Rory, looking at the result of the french guy, do you think there is some chance of machining 25mm of PVC using a good quality and rigid cutting tool?...

Boy, this thread really starts getting confusing .../quote] Thanks MagiO2 now it's all perfectly clear. I hope that in future Stepcraft will post/...