Noise and vibrations - drop the pass depth. try 0.25 as example? Its better do do this and run the machine quicker. I reduced just the DOC (Deep of ...

router spindles have terrible torque at low RPM and are often air cooled.. ----------------------------------------------- Yes, I've got sensation ...

The best solution - for plastic for example - use a single flute, max the spindle RPM, Machine with a feed of at least 1000mm/min and take shallow pas...

I`ve said it before, but the Operating Instructions state that you should work using milling cutters with a diameter of up to 3mm, so you might attemp...

@Frank, @magio2 what you wrote is reasonable, absolutely. I've spent days (!) reading american CNC forums about POM machining, the mantra says: ...

Hope I found the right words for this explaination. :huh: I need some time to deeply understand what you wrote... but I will get it, I'm sure!

Decisevely, I have reduced feed rate and, even if not disappeared, vibrations are reduced. I see now no risk for breaking the material. FOR CUTS MA...

Now I'm facing a problem when carving material deeply. My target is to mill down 19mm of material (!), apparently this cannot be done with the SC300. ...

why did you choose 6mm? Do you have a lot of flat faces? Or is it because of the length? Hi, I have to carve some 50x45mm boxes in POM-C. I've thou...

My contribution here: material = POM-C milling bit = Carbide 2-Flute End Mills rpm = 20000 feed rate = 400 mm/min (6.6 mm/s) plunge rate = 90 m...

Udates: Coanda, you're right. It's an air pump for acquariums. The model is APS 300 (300 liters per hour) produced by Tetra GmbH. Looking at the...

Hello, the idea of blocking the second nozzle it's not so bad. I will try it today. I think that's there is not enough pressure for cooling/cleanin...

Hi Frank, honestly I have no idea of what type of pump it is. It comes from Stepcraft, it was bundled with the HF500. Now it's not a home, it's in my...

I'm still playing with G-Simple, it's a good software for beginners (and to understand some gcode too). Just a couple of things: 1) configuratio...