Sorry Guys, my German is terrible, but thank you to everyone who has contributed pictures of their machines and workshops. It's great to see them all...

Not local to you, but was at Spalding on Saturday and interested in model boats amongst other things. Be very interested to see what you make as I am...

Managed to make it to the Spalding Model Engineer and Hobby Show, got to see some Stepcraft kits and meet Rory himself. Enjoyable day, good to put fa...

Your lines are cut with the cutter loaded in the direction of travel. A plunge has no sideways force, so backlash allows the effect you are seeing. ...

The stuff they overcoat car body paint is also referred to as lacquer. Very hard wearing and will stick to anodised surfaces if the surface is degrea...

If corrosion is a big worry, engraving will allow it to spread (slowly) under the anodising. I would make a mask for your engraved area, then apply c...

Beautiful, like decoupage in wood.

I have the older S1000. My problems have been down to the Delrin nuts wearing, they are not user replaceable and once worn allow the lead screws to w...

Does your V cutter have much runout ? lots of vibration when running ?

LOL so it's all straight forward... After the nightmare I had getting a PCIe card for my PC to run Linuxcnc I had hoped this would be a relatively e...