Trusted Member
Beigetreten: Jan 26, 2014
Last seen: Aug 26, 2018
Themen: 22 / Antworten: 31
Topic
Vor 8 Jahren
Forum
Replies: 1
Views: 4564
Antwort
Cutting board

its oak with rosewood both are massive.

Vor 9 Jahren
Topic
Vor 9 Jahren
Replies: 2
Views: 5013
Topic
Replies: 3
Views: 5400
Antwort
Wooden chair

Thats right

Vor 9 Jahren
Antwort
Wooden chair

hi i cut it in 5 hours but not continuously ,one hour in one day one hour other day etc..

Vor 9 Jahren
Antwort
Some thoughts after assembling my 840

I will agree with jvalencia and more for the 4 section i have sand the work holders to because when i tight The work holders they stuck, and i must s...

Vor 9 Jahren
Topic
Vor 9 Jahren
Replies: 1
Views: 4350
Antwort
Stepcraft 840 winpc starter problem!

Ok i find it the in y motor the screw was not tight enought , and now all is perfect

Vor 9 Jahren
Forum
Antwort
Stepcraft 840 winpc starter problem!

Can i ask and something else, i use one lap top old with usb1 and windows xp , is there a case that the stepcraft cable is usb2 and i loose data in th...

Vor 9 Jahren
Forum
Antwort
Stepcraft 840 winpc starter problem!

Ok thanks i will give a try

Vor 9 Jahren
Forum
Antwort
Stepcraft 840 winpc starter problem!

I must turn by hand the motor z y x photo 1 or from the the photo 2?

Vor 9 Jahren
Forum
Antwort
Stepcraft 840 winpc starter problem!

Bvs you mean with my hand to move y x z up and down?do you think that something have stuck? But it is quet strange that it make it only in cycles, whe...

Vor 9 Jahren
Forum
Antwort
Stepcraft 840 winpc starter problem!

I checked everything , all screws are tightened in position .

Vor 9 Jahren
Forum
Antwort
Stepcraft 840 winpc starter problem!

And the three cycles are cut the same , if i loose steps there are will not be the same right? I think is something with the speeds of x y z and the w...

Vor 9 Jahren
Forum
Seite 1 / 4