10000 rpm, 0.25mm depth of cut, 150mm/min feed rate Where possible Do Not plunge in, if need to then 10mm/min max I used wd40, or very light oil pri...

"Hope this is the correct thread, seems so. I have recently put the Y axis upagrade, which lets be honest should have come with the machine, however r...

Hi, What is the length of your drill, or end mill that you will be using? Long series, short series, standard? All of those will affect the max par...

Hi, Hobby type software generates tool paths in a non efficient manor and with that in mind it would want to take the tool over the top of your mill...

Rule of thumb is to support the milling cutter as much as possible into the collet. You have to be careful to allow for height of clamps and job thic...

The burnt image looks good, what type of wood is that and what feed rate did you use? I see you used/ modified an engraving tool profile for your w...

It looks like you may be cutting deeper than the flute length of the cutter. If the body( shank) diameter of the cutter is larger than the cutting di...