I made changes to UCCNC settings! I finally found the settings to keep everything working properly.

Interface specification: 4 pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)

If you have no knowledge of electronics, I suggest you buy it ready to go! Neje electronics are built-in. You must make the connections to the Stepcra...

M200 - M202 Everything goes, the Z-axis must be minus sign. (-100mm)

I changed the UCCNC to version 1.2048 and P1, P2, P3 commands no longer work. What could be the fault?

PWM min duty (%) = 1

When using the (S) code, the UCCNC needs these settings.

Error correction! My post rocesors for Aspire 8.5V. Slightly changed 'Stepcraft' offered. StepcraftV3PWMLaser_2018-08-20.rar Spindle Spee...

My post rocesors for Aspire 8.5V. Slightly changed 'Stepcraft' offered. Spindle Speed = X,Y speed of motion (F) Feed Rate = Laser Strength ...

My post rocesors for Aspire 8.5V. Slightly changed 'Stepcraft' offered. Spindle Speed = X,Y speed of motion (F) Feed Rate = Laser Strength ...

My post rocesors for Aspire 8.5V. Slightly changed 'Stepcraft' offered. Spindle Speed = X,Y speed of motion (F) Feed Rate = Laser Strength ...