If you cut two lines from a central point in both X+ and X- are they both 1mm out? It might be that the X axis is referencing too far away from the...

HI Tikka, Its great that you're building your kit. It seems so daunting at first but highly rewardable once completed so kep up the good work! 1...

Hi all, I use normal 3in1 for the screws and some WD40 Specialist Lithium grease for the shafts, I think that is overkill but it doesnt attract dir...

Does it really matter though? Assuming that it works ok..

99p each with delivery, will take a while from hong kong mind..!

Thank you very much! This looks great, I might have to try one soon, any thoughts on where to purchase the clock bits? Alex

Good points Rory, i should have clarified this in my piece! Once I finish moving house (again) ill try to do some more professional photos, but as ...

Ah, the secret panel... TAB ... Hadn't worked that one out... Thank-you ! 🙂 As it turns it would seem that the XML was damaged in some way as i re...

Great points Rory. I have glued my sacrificial layer to the hardboard and then I screw into the sacrificial layer in different locations, this seem...

Great news! I've been looking into Cut2D!

Rory this clock looks great! is it possible to share the file on here?