Looks good, I always keep my feeds low as possible as I dont think it can ever hurt to keep it slow, like you experienced, going too fast can give odd...

nice idea!

Thanks 🙂 The server seems to process them when you upload them so that they are much smaller in size, but after that it must forget the original o...

Ah what was I think of then, when you plunge in at an angle?

This is beyond me to be honest. Rorys the best man for that. I would say though that its not a good idea and you should stick to how it is! The Y m...

Ah well there you go! haha never would have guessed that!

Done and done 🙂

Hello Every body, ... I build a cabinet for it (her), because I'm leaving in a flat. So I have to limit the durst and the noise... Would you min...

You're right Tikka, those don't ring a bell to me. I've looked through my manual and I can't see them in there either..where abouts were they in t...

It happens, don't worry! Plunging (how I understand it) is when your z-axis first penetrates the material you're cutting instead of going in at 90 ...

Yeah 3in1 can go sticky, but i find that the constant movement mitigates this. Also its cheap, readily available and works! 🙂

These look great, nice one! I think I might have to get designing some animals!