I am having the same issue with my V1 S600. Are you using V1 or V2 machine?

How are you creating the file for UCCNC? I set the plunge and feed speeeds in cut2d at the point of making the file

I have been cutting some 22mm Oak recently without an issue, I use a 8mm ball nose to cove the edges 4mm which allows me to cut the Oak as if it was 1...

Smoked motor, must have been pushing it too hard!

Cool idea!

I tend to buy in bulk from China, alibaba is a good place to start. You do have to buy in bulk though..

Oh I see so it isn't actually providing any rigidity? Does it still sit completely level?

I want your cutting bed! Might have to look into this for my 600!

Nice work! What cutting tool did you use?

Once you find it make a bookmark so you can always get back in one click! When on the page you want, (for most browsers) its Ctrl+D. Ctrl+Shift...