A very good clipart library comes with Vcarve Pro and the seahorse/dish is one of those files. From Vcarve I exported it to UCCNC. I did have one prob...

I get quite a bit of flex in the table towards the end of machine (in the Z) and wondered if fitting a heavier spoil board would help prevent this.

Very good! Does it help to stiffen the table?

SO far Rory from Stoney CNC has been excellent. Very quick turn around, reasonably priced and most important, there to offer years of experience in CN...

I was going to try replacing the corrigated tube with some smooth pipe.

Hi, I also got the drag knife with my Steppi and so far I have only cut paper and thin card for a test. After a quick chat with Rory from Stoney C...

Some more

Update on exhibition project using my Steppi - Remember don't use your Stepcraft at 1:30am when tired, you Will make (expensive) mistakes! This ...

I can't say anything about the Kress, although I'm sure it is good spindle but I'm very pleased with the HF 500. Even without upsetting the neighbours...

That looks a long way off. I had a similar problem with mine, I held the screws in soft jaws in a vice and simply filed them to the correct length. Yo...

Back after a weekend away from my Steppi and yes finished! I found the the build fairly easy and very enjoyable, well done Stepcraft! There we...

Continuing on today I made reasonable progress. One of the more frustrating part of the build was feeding the cables through the trunking. I ended up ...