This might be of interest, a oak beam for a fire place longer than the machine. The beam size was 1250 x 130 x 40mm. I made a fixed reference jig (MDF...

Here is a beech breadboard, 305 x 20 x 35mm, finished in olive oil.

I use a 840 with Stepcraft HF500 spindle, high quality cutters, v-carve 6mm and 1/4" down cut end mill from Rory at Stoney CNC (also stacks of advice ...

Yes but it can only make logs!

Hi, No suggestions but I had a similar problem today on the X axis, lost steps and ended up about 20mm out - cup of tea and called it a day!

Very close to being finished - but Christmas is also very close!

I think you forgot this 😉 😉

Hi Peter, I used your settings to control my HF500 through UCCNC which worked fine but then started not necessarily stop/starting in the right order.I...

Many thanks got it - I'll look harder next time!! Now time to open a youtube account.

Can I come for dinner!

Got a bit further on today. A fairly poor cutout finally got me to level the table a job I have been putting off and like a lot of things it wasn't as...