UCCNC test version 1.2038 had a workaround for this issue. The current test version is 1.2042, and can be downloaded from the UCCNC forum.

UCCNC does not support G20/G21 modes. The machine setup units must match the g-code units. If you 2want to run both inch and metric code, you should s...

It's not so much an "obvious flaw", but a limitation of the way that MeshCAM works. To be honest, if you're mostly doing 2D cutouts, I would say th...

From CNC Drive on their forum.... Yes, unfortunately Windows 10 Cumulative Update KB4013429 which was released a few weeks ago in March 2017 is b...

Does your PC have Windows 10, and integrated graphics? If so, this is a known issue with the latest Windows 10 update.

Draw a vector down the center of your slot and use a profile cut, ON the vector. If you want to use a pocket toolpath, make the slot slightly large...

There is a known issue with the latest Windows 10 update and PC's with integrated graphics on Intel processors. It affects OpenGL display. I think it ...

I believe that the border that you see in UCCNC is your softlimits. Unless you're softlimits for the X and Y axis are both set to 0 min, 200 max, it w...

So, does the (VCarve created) GCode take precedence at run time, or do other settings in UCCNC come into play that may conflict with the GCode? Th...

You do raise an interesting point, Peter, re: driver overwritesThis is really not possible. The UC100 has a USB driver, that enables Windows to acc...

Do you have the latest Mach3 plugin installed for the UC100? You should be able to switch back and forth, and the UC100 should automatically update i...

Are you using a 64 bit OS? Mach3 can only use a 32 bit OS with the parallel port, Windows 7, XP, or 2000. And Laptops are not recommended, as most wo...

Different versions of Aspire would have nothing to do with your Softlimit message. If I had to guess, I'd say that the issue might be with your Home P...

Hi Gerry, Thanks for that - you are definitely VERY much cleverer than I !!!!!!!!!!! Not that much.... :unsure: Just passing along the info...

If you edit the M31 macro, and change this line: MessageBox.Show("The machine was not yet homed, home the machine before run to parking position!")...