Thanks a lot! It was may be not a 5 minutes job, but your help is greatly appreciated ! For some reason I had to mark output 1 has active low in UCCNC...

Thanks for those information ! I was able to configure the machine saturday with the information on the kickstarter pages… SC sent me some PDFs and a ...

Many thanks for the link ! There is much more information here that what is provided on the SC site or in the manuals… I was able to configure properl...

Sorotec answered and told me the electronics were the same in the 840. Indeed it was a mistake on my side, I did configure properly UCCNC but didn't a...

I did contact Sorotec and also StepCraft, but I'm still waiting for an answer… But anyway, thank you very much for your help ! I'll try to contact Ror...

You're right. I have a a chart in the operating instructions, except it is for the older machines. I don't know if it is a mistake from StepCraft or i...

Yes, the UC100 is connected to the parallel port of the SC840 and UCCNC is installed on my PC. I have successfully installed my license file, the soft...

Thank you very much for your answer. I didn't buy my stepcraft through StoneyCNC but through Sorotec. There is no disc nor any information on how the ...