Thanks andeleibi. I will try that.

I can't seem to change the y-axis velocity in UCCNC. I wanted to push it higher to test after y-axis alignment, but when I type in a new value and pre...

Hi Goran, I just made sure that The UC100 was as far away from the power cables for my router and Stepcraft as the cables allowed, probably 3 ft. Tha...

I resolved this problem. This was nothing to do with sticking or loosing steps, the UC100 device was this issue . I had this near power cables and it ...

Maxime, Did you manage to resolve this problem? I have just started to have the same issue. Regards David

I have just started having a problem with y axis shifting during cutting. Part way through the job the y axis shifts by several inches. It just seems ...