Hi Ogee, Just my opinion, to state from the outset :unsure: and I am sure other experienced users can confirm or rubbish my points. Firstly, yo...

Thanks Karoly. I should have also included in my original question, what would be the recommended Backlash velocity %. I could not find anythin...

Hi, Could someone advise on what to type into the backlash settings, what are the units it is referring to, I assume if my offset is 0.2mm I enter...

I was also having this issue, tried to avoid a disassemble but that's what it needed. From what I can tell my problem was the lead-screws were not ce...

Hi, Weta Workshop use one to make their large size props, glimpsed it for a couple of seconds in this video @ 1:45min

Thanks jvalencia, I changed to Exact Stop mode on UCCNC and has made an improvement on the 'roundness' of the circle but looks like it might indeed be...

Hi, yes I had considered this but I'd prefer to have the cut pieces to stay secure and not move about once they are cut/free. I was concerned that giv...

Hi, Hale2160, yes got my SC840 and original set of cutters from Rory and wholeheartedly agree with you. I am looking for odd angle cutters and jus...

Thanks for the info. MagIO2, hoping to use them on scale models, adding separation lines between sheet metal panels, control panel buttons etc.