Yes, the pin connections are good. There is one more thing that think me about failure: the temperature doesn't stabilize around the setpoint temp...

Finally, i'm somewhat disillusioned with the 3D printer. The 4th axe doesn't run; the PLA's flow observed came from only the internal pressure and sto...

Hello, I resolved my problem. The stepcraft works fine now (milling+ 3dprinter). Two wholes: The temperature must be adjusted first, turn off...

Rory thanks for you help. Unfortunately, i'd already used your configuration (only with the change of the port with Ox378). In this case there are no ...

Hello, i've purchased stepcraft 300. I use it to mill and 3D print with Mach3. For milling, i've no problem, all it's correct. My problem is...