Hi, I use strip brushes from Mink. But I have a DIY made suction head. Here is the link: I bought them here: Enobi BR Roy Hi Roy. ...

Here are some media from today's attempted neck cut. The upper side cut went just fine as did the lower side... right up until my wife came back and t...

Today I had a go at making a perspex/acrylic template to align a CUT and radiused fretboard to a StewMac style dual scale fret slotting template: ...

I disagree - I got the 2/840 (same machine but just bigger), followed the instructions to the last dot and my Stepcraft almost immediately went to the...

Sold... £750 was it?

You can trust it, you just need to measure and set it up correct. I use mine since the beginning and won't miss it anymore. O.k. so I reinstalled mi...

MagLev!!! 😆 Chortle.

This is another aluminium cut with exactly the same parameters as the previous post. This is a small potentiometer and capacitor plate today. Here is ...

Yo Doug, some braincell woke up from deep slumber. A Brian May Red Special? Do you mean this Brian May? Brian Harold May, CBE (born 19 July 1947) i...

Hi Doug, You arrived at values completely different than mine to process the same material! I'll be damned if I understand this :woohoo: Happy...

Thanks for the tips MMorao. You might have already seen my post but I successfully cut 3 mm acrylic sheet: Material: 3.0 mm (nominal) cast glo...

Superglue??? Duct tape no less! Seriously, use Threadlock which is made for the purpose. Recently I made a similar comment in some humor forum that...

Is the thread stripped? It is difficult to discern from your photograph but it looks like that might have happened if you cross threaded the nut.

I guess it should be easy to find out via a Google search what a 2 Watt laser will cut. I could use it to prepare wood veneer between 0.5 and 1.5 m...