Depending on your direction setting of the Y-axis the macro maybe should have a different setting. Here´s a modified zip file: UCCNC_softlimits...

Hi tjandra! great! Did you configure the e-stop Pin as shown in the attached screenshot? Did you connect the e-stop button as shown i...

Hi, there are many things that can cause this behaviour. So here my idea. Did you read the manual? If you havn't one here a source: Manual Check...

Hallo Marvin, Die Daten von DocBrown werden dir nicht viel nützen, denn sie sind im G-Code erstellt und den kann die Starterversion nicht. ups...

Vielleicht verstehe ich das Problem ja nicht... :whistle: Ich habe Deine PLT Datei in ESTLCAM 9 geöffnet (ich nutze sonst immer DXF Dateien), eine...

Ich habe ein paar MACRO-Tasten des Handrads belegt, so dass es sehr einfach ist, in UCCNC die SOFTLIMITS einzustellen. Taste MACRO-1: SOFTLIMITS hi...

🙂 :cheer: 😆 So everything is perfect now...time to start milling... show some pictures of your results... we are waiting... 🙂

Have you seen this one: MacroSharing Maybe that will help...

Hi, can't really help you directly since I don't have the tool changer but what I know is, that all the macros are taken from MACH3 and not tested ...

Today I got my handwheel after 3 days delivery directly from a store in Germay. Works pretty well! 🙂 For those who want to buy it also some addition...

Hallo Uli, besten Dank dafür. Ich hatte auch vor langer Zeit mal ein funktionieredes M31 ins englischsprachige Forum eingestellt, welches ich in ei...

Are there any differences between the drivers for UCCNC and MACH3? I found this one on ebay: Handwheel There's no word about UCCNC compatibility...

...ich vergaß...ESTLCAM 8 läuft einwandfrei, d.h. Start nach 2-3sec...