Didac
@didac
Active Member
Beigetreten: Mrz 5, 2016
Last seen: Mai 31, 2016
Last seen: Mai 31, 2016
Follow
Antwort
UCCNC Steps per units
Thank you very much to you, Voltatus and DocBrown. both are right, i was working with the profile for the stepcraft1, now with the new profile its ...
Vor 8 Jahren
Forum
Antwort
UCCNC Steps per units
Thank you very much, but i can't find this parameter in the UCCNC configuration, where is that parameter?
Vor 8 Jahren
Forum
Topic
Antwort
PROBLEM starting with UC100 with mach3 UCCNC in W7
Thanks, the drivers works, the issue is the software UCCNC don't find the device. i wrote to CNCdrive (UCCNC supplier) for buy the software, and th...
Vor 9 Jahren
Forum
Topic
Vor 9 Jahren
Forum
Replies: 8
Views: 9625