I have float in my Series 1 S420 Y axis lead screw nuts - do the series 2 lead screw nuts fit the series 1 machines?

Thanks for the replies. As I get my workshop sorted out, I'll clean my machine from top to bottom and look to do what has been suggested here.

This was the last time I used my Stepcraft printer - life got in the way. However, I now have need of it again - routing carbon fibre flat plate part...

I have milled and drilled al. plate to make a cover plate for a water outlet on an old MG, using my stepcraft machine. I use fusion 360, peck dri...

I downloaded Mach 3, and I see there is a plugin for the UC100. The program ran in demo mode just fine on my win7 64bit desktop. Will try it on the ...

Yeah, I got two varable flow connectors with my pump. I used a short piece of tubing and a fully closed connector so its still completely useable sho...

If its the same as the one I received, its made primarily for aquariums. Initially I would have one of the outlets blocked off and then the other w...

Okeydokey, I took some time to compare the paths produced by 3 likely post candidates. WinCNC, Mach3, RS-274D. Here are a couple of images - th...

I think, at this point you need to get back to Sorotec and ask them for a profile. If that fails to get you a profile, Rory might be willing to help.

Thanks guys, I'll be sharing anything interesting. The 3D printer is a Rapman 3.1. I bought it as a kit a few years ago. The firmware is closed...

I had tried the mach 3 post. I will try it again later today, in case changes I made to the operations afterwards made the model more optimised for t...

No problem. So you have the uc100 parallel port device plugged in to the parallel port card on the machine? To have the software operate outsi...

That's good news. Thanks for the info.

They should be on the plain disc you got with your package - open it up and you should see a number of folders, go through the folders a step at a tim...