Hello ozone, in what program do you draw and generate your G-code? Normally you can create numerous toolpaths and profiles in one drawing/project....

After contacting the stepcraft service desk the problem is likely solved. Anyone with a SC series 1 has to replace the toolholder (part 3) with one...

Hi J5D, Nesting is possible and best done in Fusion before generating the g-code with the post-processor. There is also another program that can...

did you check if the emergency button isn't pressed?

Huff, All plastics and acrylic variations are hard to mill because they are all sensitive for heat and will melt and stick to the mill bit and crea...

Strong, as inflexible as possible to bending, warpage Accepts paint without loss when slightly bent Nice contradiction in terminea:whistle: ...

Not happy about the new design, you couldn't be more right. It is a horrible design. Hope they change it back.

Danny, If its like Peter says, it only happens in your Z-axis and halfway through your project, you have fantom in your machine 👿 or something...

Danny, It looks like your machine is fine tuned baut still loosing steps. Have you checked you computer? Make sure that the USB/Parrallel connect...

Herr are the plans for the S 420 enclosure. The electrical schematic and components are left out, they only comply with NL parts. But that is very...

Just like Alpenkreuzer says you can find these drawings and more on www.makecnc.com I am not allowed to share the sold drawings from MakeCNC. So sorr...

Ok I will post the plans for the enclosure, but you have to wait until I have made the drawings. I draw this SolidWorks but didn't finish the drawi...

Ok Maybe I can help you. Where you from? Who is controlling your CNC depends on the settings you made or not made in WinPC. Normally VCarve will...