Yes I had that same problem with my DIY enclosure. But I made a hatch in the backside as wide a the machinebed and (2 inch) 50mm high just for plate ...

Hello Andries, Why extending your bed? Did you consider to flip your work-piece, then you have almost a double milling area. It works for me:) ...

Hello Harm, The timer module is a Vollcraft DHHM230 from Conrad. I made my own PCB design and add the switches and add a power supply. that's a...

Harm, Brave to start with the most difficult material. Aluminium has many different types Alloys so if you want to mill try to get some of the NEN...

Hello Harm, The toolchange should be at "normal" speed even when changes occur more times in a project. First witch version of winpc do you use? ...

Hello, I tried to contact Fraxeon a few years ago, and even than they didn't reply on any of my mails. this was my reasone not to buy from that co...

For the best result you should buy a 6 mm collet, however you can buy a 6mm flat head bit with a 3,17mm shaft; remind that you have to reduce the...

secure your sacrifice plate to the machinebed create a pocket square in the max size for your machine. use a flat bit of 6mm or larger if you can ...

saslanis, I'am not sure but it looks like the mm1000 is a clone of the Kress 1050FME. The rpm for the Kress 1050FME are: 1 5.000 min-1 2 7...

Hello that depends on wich software your machine is working, You use UCCNC or WINPC-NC? For WinPC-NC, use WinPC-NC ATC Arcs mm (*.nc) for 2, 2.5 ...

Welkom Harm, Ik hoop dat je nog veel mooie dingen gaat maken op je steppie. Je kan hier hier altijd terecht met je vragen en het delen van je "pro...

Thanks, will check it out, hope I find the right flux/paste for circuit boards and smd components.

Great job, Looks very good. What brand of flux you used?

Hello Scott, The Control panel for my steppie consists of the following features. The Red switch is the main power (for the spindle and ...

Why do we have German topics on the English forum site?