To all, I have found the right way to use the laser and PWM modulation in WinPC-NC. You can find the procedure to set this up on: topic: Laser c...

Ivo, I don't use UCCNC so I can't help you on this one. To convert images into G-code for laser application try Inkscape (free) ; And there a...

The physical limitation of speed is the strength and speed of the stepper-motor. The dynamic speed is depending on how the G-code is generated and po...

Ivo, Yes you can, but not as fast because the stepper-motors are the limiting factor. But if you can buy this machine for $150 I suggest to buy it...

Harry, Grinding on the end of the Y-axis (long one) can be caused by the front mounting of the front panel part and the front panel restrainer. ...

kekstuete, I use a USB connection direct on the Stepcraft motherboard. and on both questions the answer is Yes. Here you can see how I connect...

Check your cables Most common problem is a bad connection between the board and the switches. Second disable the fourth axis in WiN-PC good lu...

Mihael, most important point is to get rid of the chips. Do this by vacuum dust suction or air blast during the milling process. There are several s...

check your connections of the Stepper motors to the mainboard and/or the endswitches. This error shows when a connection is bad or broken. In winp...

Check out WinPC-NC USB You can try the starter version for free good luck

Alex, Yes that is the correct one to buy. suc6

To control your laser I made a control box that fits into the enclosure. The complete files and PDF can be found:

I figured it out, In this section of the forum the answer is given. How to.... get it working with WinPC-NC happy lasering

Hello Guys, I 'am always surprised about the assumption that the forum members must known what the configuration is creating the problem.. If yo...