Last seen: Sep 9, 2024
First reaction is a flaw in your G-code. It looks of the code jumps in the X-directionele in the second or third pass.
NIce question However we are no physics who can determine what machine you own or what the configuration is. So next time give valid information b...
" Why does an issue with ethernet cause issues? Wouldn't you have the same problems with USB? " You have a point here. When loosing the connection...
Hello David, A D420 is ok for RC plane building only think twice on how big your planes will become in the future and if a D420 is than still suita...
Happy to be of help for you. enjoy your steppie
you can easily test the stepper by changing the wires to the X-ax connectors on the control board. That's if your X-ax is working correctly.
Hello EJ You can find a air assist/smoke exhaust especially for the Stepcraft D-series on: But in a few days there will be an improved design po...
most problems occur due to bad wiring. check your connections and wiring from the e-stop switch to the motherboard.
Hello Brian, first of all congratulations with your new machine. I suggest that before you start with the software you first check if your end-s...
it all depends on your demands and wishes. Keep in mind that you can mill almost everything you want, but........ Stepcraft is in origin an hobby ...
What CNC control software you are using? Is it Winpc-nc or UCCNC? Possible solution is to reverse the Z height in the control program since you us...
Correction on my previous. "Your question "Does EstlCam can be used for creating plt files ?" Answer Yes." The answer is actually NO. But wh...
Your question "Does EstlCam can be used for creating plt files ?" Answer Yes. But your problem lies in Winpc. First off all WinPC-NC is a very po...
"Is there a way to put starting point in the center instead of lower left corner?" Yes, but is has to be done in the program that creates the G-cod...
can you submit a G-code example ? and a wiring sceme pin connection of your SD15 connector ? What laser (brand/type) do you use?