Teamtrapped Jeroen, check your private message 🙂

Can you show a picture of Cut2D in drawing mode without toolpath?

Good luck 🙂 And a little bit of extra advice Check out the (video) tutorials about VCarve at the vectric website. They are really very helpful to...

Can you send me all your settings in WinPC-USB? By mail is also fine and Dutch is perfect:)

Jeroen, You will never see you tool settings in the WinPC program, they are generated within the G-code and will be read by WinPC. You can see the...

Hello idecorwalls, engraving in acrylic is a bit of challenge. First how deep are you planning to engrave? Second is the engraving pocket style o...

I have the files in Aspire/Vcarve format or DXF available for those who want to make this. Oh and sorry the correct dimensions are L 50 x W 25 x H 40...

hakim..., so far nice job done, but your problem is the Y-axis. Probably you have tighten the screws on the front and back of the table to tight. ...

reverse z-axis coordination?

Hello Aksuhoo, Welcome to this forum. First of all there is no real answer to your question. It depends on what your intentions are so answer the ...

Chris, What program do you use for your machine WinPC-NC or UCCNC? Because it looks like your Z-axis is not clearing to a save height after measur...

Bubbatt, Sorry to read it didn't work out. Yes, if your motherboard has a problem I am finished with suggestions. But still it puzzling me because...

Bubbat, I have start-up my system and give you my settings witch are working. I only use WinPC-NC USB in this setting so NO uccnc, just a USB cabl...