hello, I asume you use WinPC-NC as your controller program? Did you encounter earlier problems with your code or is this the first step in milling? ...

Hi Zhoot, This is the explanation of the "Error" message from the original manual. "Machine not ready The machine has not been switched on or a f...

Hello, "Not Ready" warnig is mostly a not functioning communication of one of the steppermotors. So check if the X-Y-Z cables have no wirebreak or...

Ok try the next option. Check in Win-PC the tab: > Parameters > Basic setings > X-axis Check here "Invert movement direction" If this is...

Check in Win-PC the tab: > Parameters > Import Formats make sure to check if the "invert Z coordinates" is checked and that you use the G-code...

Yes you can. How that depends on which control software you use.

do not use this forum for support from stepcraft they will not respond. write an e-mail to stepcraft or your reseller that gives you a better change

Alan Than it seems that your isue lies in the sofrware. Somewhere in UCCNC software is a missing setting for your end switch. I can't help you fu...

Alan Check if your Y-ax will reach the end switch and can press it.

Anthony, If you use G-code you must invert the Z-axis in WinPC. Go to >Parameters>Import Formats. and place marker at "Invert Z-coordinates". ...

Hi, Most problems in sudden changes or strange behaviour of your machine are communication related (unless you have a corrupted G-code). Or the US...

hello, first your stepcraft is not an AI machine so it doesn't think, it just does what its told to do. When a program suddenly stops it can be the ...

The First of all welcome. Second the answer is no. Aspire will however calculate the toolpaths for two diameter mills in the pocket function. Selec...

hello, in my limited knowledge of coding I thought that if you use an "IF" statement it shpuld be followed by an "ELSE" statement. I'am missing th...