Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Evaldas
@cerniauskas
Active Member
Beigetreten: Jul 11, 2015
Last seen: Feb 26, 2019
Last seen: Feb 26, 2019
Follow
Antwort
Eurotools24 G-500 miller
maybe in sc600 it is fine, but in my opinion for 840 axis the belt narrow, and tooth is to low (must be atleast 5 not 2.5) well. the belt is not bad f...
Vor 8 Jahren
Forum
Antwort
Eurotools24 G-500 miller
Yeah this is a good one 4 motors are the best, sadly i have sc 2 840 and the belt is really bad choice. But this is the beast 12000 mm /min.
Vor 8 Jahren
Forum
Antwort
Eurotools24 G-500 miller
Yeah this is a good one 4 motors are the best, sadly i have sc 2 840 and the belt is really bad choice. But this is the beast 12000 mm /min.
Vor 8 Jahren
Forum
Antwort
Issue with the Y axis: is the belt worn out?
Maybe is chance to install 2 motors on y axis? Then the belt is not needed.
Vor 9 Jahren
Forum
Antwort
Issue with the Y axis: is the belt worn out?
Same problem here too. My SC2 840 works very well and boom, y axis loosing positions. And second belt have damaged. How much this belt cost? And maybe...
Vor 9 Jahren
Forum