Hi, I have a 600 but think the stepper unit is the same on all sizes it is just the back plate is different. From the orange back plate to back of st...

HI, yes you can increase the 'Y' velocity, the reason you may not be getting the increase is because with UCCNC after changing any figures YOU MUST th...

Hi, yes board has two lights alongside the power plug. End switches connections have no polarity but MUST be on the two outer connections, middle con...

Hi, make sure all wiring is correct, on Faceboard Page, one chap had the hall sensor extension lead had become disconnected another had the micro swit...

The Hall sensor leads and connectors are standard Radio Control Servo items, the picture shows a clip which holds the plug & socket together, read...

Hi, when initially setting up, just make sure both gantry arms are the same distance from the frame, then when gantry is 'Homed', as each arm touches ...

Hi, I have fitted kit with no problems, but had a thought, make sure your wiring is all correct, if micro switches or motor wires crossed, then wrong...

Hi, I do not have an enclosure, I use Vectric Cut2D, which has 'Tiling' if the piece you are cutting is no more than the maximum 'X' width, once set u...

Hi, I have fitted them all OK and even with no real adjustment they improve the movement as they are slightly longer, but replace the original ones. E...

Hi, very nice work, well done. There are two main types of cutter, 'Down cut' and 'Up cut', this relates to the direction of the cutter spiral, the st...

Hi, to be able to turn the screws by hand the Unit must be turned off, because when power is going to a stepper motor it is active even when not turni...

Hi, Kress collets not ER but very simular in the way they work, look at this site Sorotec www.sorotec.de they are in germany but have an english websi...