Adrian M
@adrian-mahovics
Active Member
Joined: Jan 13, 2015
Last seen: Mai 24, 2016
Topics: 0 / Replies: 6
Reply
Play in all axes 🙁 Frustrated new Stepcrafter!

Yes, Unfortunately same here.. 🙁 I have just sent an email to Stepcraft and hope they will came back to me soon. I am also little discouraged as I wa...

9 Jahren ago
Reply
SC Arduino Shield für EstlCAM

OK, I just got it. Step craft was selected, BUT for some reason it was showing Steps / Rev 1800... I just opened again and selected again Stepcraft AN...

10 Jahren ago
Forum
Reply
SC Arduino Shield für EstlCAM

Agree on all of this. I might just live those sensors alone.. I just need to figure out why its making the work piece 4x bigger than is on the drawing...

10 Jahren ago
Forum
Reply
SC Arduino Shield für EstlCAM

So here is the picture as promised. I did not wire up the Limit Switches yet as I did not want to believe that all 3 wires are going into the same No:...

10 Jahren ago
Forum
Reply
SC Arduino Shield für EstlCAM

Dear MaglO2, Thank you very much for your help. Thanks to you I managed to figure out and now is working well. I post 1-2 picture in a few minutes ...

10 Jahren ago
Forum
Reply
SC Arduino Shield für EstlCAM

Hi I am Adrian and just joined your great forum. I know it is the German site but this is where I find my topic.. Can anyone please tell me the wi...

10 Jahren ago
Forum