Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Software
4
Beiträge
3
Benutzer
0
Likes
4,656
Ansichten
Themenstarter
Hello
i am using a design spark mechanical and meshcam and stepcraft 2 600 .
My question is what file type should i be saving my files in as there is a whole list of them and stepcraft is not on the list
some thing is not working between UCCNC and MeshCam ,the first pass is good. But the 2nd pass goes wrong.
It's supposed to do 1.5mm Every pass BUT on the second pass it Want to DIG A Hole and break my mill bit
Veröffentlicht : 12/08/2016 1:40 pm
For further investigations you can download the NC-Correcor:
Simulation and simulate it.
Then you know that your G-code is ok.
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
-----------------------------------
DK5LH/G11
Veröffentlicht : 12/08/2016 4:43 pm
Themenstarter
It must be all to do with the post processor
What do you all think or is it the Machine causing problems
Veröffentlicht : 27/08/2016 12:16 pm
Z axis stalling on retract possibly - check Z axis. Mechanical tuning
Veröffentlicht : 30/08/2016 9:31 pm
