Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
UCCNC Reset logic error message and Limit Pin
Software
1
Beiträge
1
Benutzer
0
Likes
63
Ansichten
Themenstarter
I recently purchased a secondhand Stepcraft 2 420 with a U100 interface and UCCNC software. After some difficulties I finally got UCCNC working and properly linked to the Stepcraft machine.
The problems I'm now having are with the configuration of UCCNC and limits on each axis. I can jog on every axis but when I get to the end either the motor continues or UCCNC flashes the res t button but when I press it I get an error message saying "The reset logic of the software is active ...."
I can toggle Limit -pin Active Low to on and press the reset button but as soon as I use the jock control the reset button flashes again and when it is pressed I get the same error message.
Any help gratefully received.
Veröffentlicht : 18/01/2019 10:06 pm
Forum Information
- 44 Foren
- 7,519 Themen
- 63.5 K Beiträge
- 4 Online
- 26.4 K Mitglieder
Unser neuestes Mitglied: Richardreild
Letzter Beitrag: Stepcraft und Powerline Adapter
Forum Icons:
Das Forum enthält keine ungelesenen Beiträge
Das Forum enthält ungelesene Beiträge
Themen-Icons:
Unbeantwortet
Beantwortet
Aktiv
Heiß
Oben angepinnt
Nicht genehmigt
Gelöst
Privat
Geschlossen