Notifications
Clear all
Software
1
Posts
1
Users
0
Reactions
3,448
Views
Topic starter
Hi,
Just suffered an oddball fault when running my SC420/2 this afternoon. Homed the machine and then asked it to "Go to zero" - whereupon nothing happened and the UCCNC s/w froze. Rebooted the machine and reloaded UCCNC 1.2021 - same thing again. A file is corrupted somewhere I suppose. Annoying waste of time as I was just about to start a job!!
Took this opportunity to download and install Rev 1.2029, copied license and profile data and sanity is restored. Hallelujah!!
SC 420/2, Industrial VFD spindle from StoneyCNC
UC100 + UCCNC
Cut2D, Autosketch10, Draftsight, Eagle 9.5.1
There is no problem, however simple, that cannot be made more complicated by thinking about it.
Posted : 28/01/2017 5:52 pm
