Benachrichtigungen
Alles löschen
Software
4
Beiträge
3
Benutzer
0
Reactions
9,272
Ansichten
Themenstarter
Hello,
Just got my 840 assembled. Went through the software install step by step but there seems to be something wrong.
When I boot UCCNC I get the typical message "valid license key not found program will run in demo mode". On the UC100 parrallel input unit only the green light on the left is on. When I first boot UCCNC the blue light on the right blinks once and thats it.
I have tried all the solutions I have found online. I believe the license key is correctly placed in the UCCNC folder so I'm not sure why the program wont read it. I have also checked to make sure the drivers have installed correctly so I don't think this is the problem. Slightly frustrating to get this all put together but not to be able to get it to move.
Anyone have any potential solutions for this?
Veröffentlicht : 17/01/2016 7:53 pm
When I got the UCCNC software for the first time, I received an invalid key.
I contacted the developer and he sent me the right key by email.
Just contact him and specify the S/N on the UC100 dongle.
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Veröffentlicht : 17/01/2016 8:38 pm
You have the wrong license key - where did you get your UC100?
Veröffentlicht : 18/01/2016 10:39 am
Themenstarter
Directly from Stepcraft USA with the machine.
Veröffentlicht : 18/01/2016 2:49 pm
