STEPCRAFT on IMAC

https://www.youtube.com/watch?v=UwH2RtuQreg

Nice illustration of STEPCRAFT running on an iMac.

• Illustrator on the iMac was used to make the geometry
• VcarvePro was used running Windows Partition to run Vcarve to generate toolpath
• Mach3 running on same Windows partition used to control machine

Whats interesting here is that the USB compatibility. The machine can be controlled via the USB connector with the Windows partition running. Neat setup. Didn't know it was possible.

Thanks to Cathal Murphy for this work. Here is Cathals page