Benachrichtigungen
Alles löschen
Show us your Stepcraft Creations
8
Beiträge
4
Benutzer
0
Reactions
4,147
Ansichten
Themenstarter
This was my first piece after building SC600 - not counting the abandoned works while tuning the Stepcraft!
SC600
HF350
1/8" 60deg V-bit
1/8" spiral up-cut
9mm plywood
The up-cut gave it a fuzzy edge that I gave a quick rub with (very rough) sandpaper. Intended as a throwaway piece but my wife took a liking to it and asked me to make a stand to go with it. The stand took me longer to make than the cross - failures of a newbie. 😉
Donald
Donald
Learning from mistakes until I become an expert!
Veröffentlicht : 28/12/2014 5:35 pm
Very nice first try! So, we can expect to see some real masterpieces from you once you feel familiar with the steppi :woohoo:
SC 420 mit DIY parallel + Proxxon mit Mod + HF500 + SprintLayout + LibreCAD/QCAD + FreeCAD +WinPC starter/USB->EstlCAM + EstlCAM LPTAdapter + EstlCAM Handrad + DIY Vakuumtisch
Gruß, Andreas
Veröffentlicht : 28/12/2014 6:50 pm
Very good demonstration of what Vcarve Can do when coupled to the SC 🙂
Very impressive first efforts. keep up the good work.
Veröffentlicht : 28/12/2014 6:58 pm
Themenstarter
Thanks Andreas - no pressure, eh?
Second project (still on the Celtic theme) - coasters! Two still to cut 🙂
Donald
Learning from mistakes until I become an expert!
Veröffentlicht : 28/12/2014 7:05 pm
nice one =)
what tool did you use for your vcarv path ?
Gruß,
Manuel
Beruf: Programmierer C, C++, C#, Delphi Pascal für Embedded Systeme (8051, PIC, AVR, AVR32, ARM) sowie PC Applikationen.
Veröffentlicht : 28/12/2014 7:17 pm
Themenstarter
90degree 6.4mm (Dremel bit no. 640)
Donald
Learning from mistakes until I become an expert!
Veröffentlicht : 28/12/2014 9:09 pm
ah damn sry ^^
i meant with which software
Gruß,
Manuel
Beruf: Programmierer C, C++, C#, Delphi Pascal für Embedded Systeme (8051, PIC, AVR, AVR32, ARM) sowie PC Applikationen.
Veröffentlicht : 28/12/2014 9:17 pm
Themenstarter
VCarve Pro from vectric.com
Donald
Learning from mistakes until I become an expert!
Veröffentlicht : 28/12/2014 10:21 pm
