Benachrichtigungen
Alles löschen
Operation
2
Beiträge
2
Benutzer
0
Reactions
7
Ansichten
Themenstarter
I've got a M.1000 with AMB spindle, currently working on a large batch of all the same pieces which need to be cut..
but suddenly I have this issue that the program stops due to a trigger I cannot determine which one...
after pushing the reset button I can continue working... but now it's every few seconds it stops..
In the diagnostics I cannot find anything which triggers this. I've cleaned all switches, but I'm wondering if there are other
safety points I need to check ?
thx, Mike
Veröffentlicht : 17/01/2025 12:09 pm
Sorry for the late reply and maybe you have already solved your problem.
If the problem is triggered every few seconds then is it possible to start the program, switch to the diagnosics screen and see what happens at the moment the problem occurs? Is there anything flashing for a short period, causing the error and then disapearing again?
Do you hear any stange or unusual noises? Is everything running smoothly during the (short) period that there is no problem?
Does the problem also occur if you reduce the feeds and speeds to say 50% of what you use to apply?
Kind regards,
PapaAtHome Ich lese Deutsch, ich spreche (ein wenig) Deutsch, aber ich kann kein Deutsch schreiben.
SC420/2+Perf kit, D3/600, MM1000, laser module, WinPC-USB v3.02/06, UCCNC v2111, FreeCAD/Inkscape on Windows10, 64 bit.
Veröffentlicht : 21/01/2025 5:31 pm
