file Frage Tool not droping of during Automatic Tool change

Mehr
20 Jun 2022 15:04 #62439 von MrJarl
Our Automatic Tool change is working 90% of the time we use it but then every now and then the tool just doesn't come off.
So when it tries to change to the new tool the first tool is still on making it drive down the first to into the second tool wich breaks the first tool.

Does anyone know why this happens?

Dieser Beitrag enthält einen Bildanhang.
Bitte anmelden (oder registrieren) um ihn zu sehen.

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
08 Mai 2023 20:04 #63120 von [email protected]
I had the same problem.

If you encounter burnmarks on the SK 15 tool holder, you are running to fast with the feedrate.
The SK15 holder is not as rigid as the collett on the spindle without a n ATC.
Therefore you must increase rpm to 20-22000 and set the feedrate to about 2000mm / m

Also you can have to little pressure on the air. You need at the minimum 8 bar pressure. This means you have to have a 810 bar compressor.

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Powered by Kunena Forum

© 2022 STEPCRAFT GmbH & Co. KG

Wir benutzen Cookies

Wir nutzen Cookies auf unserer Website. Einige von ihnen sind essenziell für den Betrieb der Seite, während andere uns helfen, diese Website und die Nutzererfahrung zu verbessern (Tracking Cookies). Sie können selbst entscheiden, ob Sie die Cookies zulassen möchten. Bitte beachten Sie, dass bei einer Ablehnung womöglich nicht mehr alle Funktionalitäten der Seite zur Verfügung stehen.