Benachrichtigungen
Alles löschen
Operation
6
Beiträge
6
Benutzer
0
Reactions
2,841
Ansichten
Themenstarter
Hello,
I have problem homing my machine. I am totally new to the CNC stuff.
Here is video:
https://youtube.com/shorts/ujMU0ZzPI8k
When I press "home all" the Z axis starts moving up, reach top and starts moving down. It makes weird noise while moving down and stops after few seconds. Then I must reset the whole machine with the big red button to be able to control it again.
I searched a little on internet and tried setting the soft-limits to 1000000, but it made no difference.
Do you have any idea what is the problem? I bought the kit, putting it together myself, so it might be even problem in assembly. I took the Z axis apart, but saw nothing obvious. I know I had problems in the assembly with the thin sheet metal flaps activating limit switches, but I think they should work fine now.
Do you have any advice, please?
Veröffentlicht : 12/05/2022 10:31 pm
Hello, Strape. I am newbie, as well. As well I encounted same problem as you. How did you manage to fix this problem?
May be you now know some useful resource for newbie CNC regards?
Denis
Veröffentlicht : 26/11/2022 11:29 am
There are two fix you can try.
1. Start the home sequence and push the lower z limit. If it then moves in x, you must adjust the metal lever on the micro switch, so that it engages earlier.
2. When mounting the z axis, it is possible to squeeze the cables, so you get a grounding problem. Remount the z axis, and look for squeezes cables.
Veröffentlicht : 09/05/2023 12:44 pm
Same problem here for me. but when i home, my x axes tries to go out of the frame.
Veröffentlicht : 13/05/2023 11:56 am
Hi
I have the same homing issue that you posted, may I please know how did you fix it
Cheers
Maj
Veröffentlicht : 11/10/2023 12:52 am
Hi
I have the same homing issue that you posted, may I please know how did you fix it
Cheers
Maj
A problem I had when doing some of this was that the soft-limits were set and it might be that. Its perhaps not the full story but
it might be something to check. Just remove soft limits while you try out.
Veröffentlicht : 16/10/2023 10:11 am
