Benachrichtigungen
Alles löschen
Operation
2
Beiträge
1
Benutzer
0
Reactions
2,831
Ansichten
Themenstarter
Fully assembled machine, everything works fine except I can't seem to get it to change tools. I didn't see any documentation on tool changing for this spindle. It has 10 tools and the rack is supposed to move in. I found a setting in general settings to "Run the tool change macro M6". M6 T2 does nothing. Not even a message. Is the M6 file supposed to be set up already, or do I have to set it up? If so can you point me to the manual?
Thank you so much.
-Anthony
Scojet
Veröffentlicht : 13/09/2021 10:15 pm
Themenstarter
Figured it out, the M6 file is on the USB they gave to us and you have to make sure the silver toggle switch on the tool change box above the spindle is toggled DOWN. Props to Brandon at Stepcraft for helping me out.
.
Veröffentlicht : 15/09/2021 12:30 am
