Frage Got first run today , a little ? tho..

I really wont have it go to back/left after a job, so i keep the 1 G28 to go safe up, but remove the last G28 XY and keep Z there to, much better if i have to change tool ie..

If you have to change the tool, the machine only goes up at the actual position. G28 0 is only at the very end of every job.

BR,
Ronald

For now i run all jobs one at time, i enable Tool change in Mach3, so i can now start use all path in one file and manual tool change, but not before i have testet it out by air cutting..

Got finally after 1.5 weeks my new Ender 2 3D printer so I can make an adapter for my old Old Power craft (Dremel copy) that is bound together for it's not in two parts
The thread on the adapter fits perfectly, so a good tight and firm holder that also fits perfectly into the 43mm engine holder.
Made two 6.1mm holes in a homemade bottom plate and for the corresponding item, namely for a later two-sided milling, the holes were about 5.92 to 5.97mm, so a loss of about 0.14mm, think it's ok as the first test, but should probably achieve a slightly better presidency, right?

And a picture of it ofc...



Well cant get image to work..