Benachrichtigungen
Alles löschen
Operation
5
Beiträge
4
Benutzer
0
Reactions
9,170
Ansichten
Themenstarter
I have some issues with limits. I wonder if somebody can quickly spot what might be wrong.
The specific Stepcraft 2/840 machine profile is loaded as required. I have been 'tuning the axis' and all were running smooth.
I then pressed 'Home All' Z Axis (No problem) - X Axis moved and at its limit 'bumped the gantry' and triggered the stop. I received an error message "reset logic software is active etc......" (see attached image). I was unable to override this
In the diagnostics panel (see attached image), all three X limit -, Y limit -, Z limit - green inputs and all three X home, Y home Z home limits are permanently lit.
What am I doing wrong? and how can I fix?
Cheers
Rich 🙁
Stepcraft 840
Kress Spindle
UCCNC
Vectric Aspire
Veröffentlicht : 05/07/2017 6:54 pm
Hi,
There is one input linked to all three homing switches in series, opening this one line will light the X, Y,and Z limit switch indicators as well as the X, Y and Z home indicators. The would normally be out of course.
If the line is permanently open, then the system will be in "RESET" state and no movement command will be actioned.
You will need to power off the control board and probably close down UCCNC (I'm not sure if the USB connection remains intact if the control board is powered down), then manually move the problem axis (X ??) until the limit switch closes - assuming it is still in working condition. This should re-establish continuity through the homing switch line and allow the system reset to be cancelled. Check this with a test meter if you have one.
I'm not too sure how the machine ended up in this locked out state, maybe the X-axis didn't move away from the limit switch when commanded by the homing software.
Let us know how things progress.
Peter
SC 420/2, Industrial VFD spindle from StoneyCNC
UC100 + UCCNC
Cut2D, Autosketch10, Draftsight, Eagle 9.5.1
There is no problem, however simple, that cannot be made more complicated by thinking about it.
Veröffentlicht : 05/07/2017 10:58 pm
Themenstarter
Hi Peter,
Thank you for the advice. I eventually rewired the board and checked all the limit switches and through a process of elimination found out it was the X Axis Limit Switch that is faulty. The switch had 'triggered' and not rebounded
There is a small metal plate that hits the 'trigger switch and that was 'slightly out of alignment' and had stuck holding down the limit switch. A slight adjustment and all is fine now
Its been a pain stripping down the machine. Once again thank you for your help
Cheers
Rich
Stepcraft 840
Kress Spindle
UCCNC
Vectric Aspire
Veröffentlicht : 07/07/2017 3:27 pm
My Stepcraft2 D840 can't home. When I press the Home all button the z axis moves downward and stop at its limit but the coordinate is still running. How can I solve it?
Veröffentlicht : 10/03/2020 5:04 pm
Wrong direction.
The home position for the z axis is upwards. So, two choices:
Change the direction in the software or change the wiring of the Z-Motor. Just swap 2 wires.
SC 420 mit DIY parallel + Proxxon mit Mod + HF500 + SprintLayout + LibreCAD/QCAD + FreeCAD +WinPC starter/USB->EstlCAM + EstlCAM LPTAdapter + EstlCAM Handrad + DIY Vakuumtisch
Gruß, Andreas
Veröffentlicht : 10/03/2020 7:17 pm
