Benachrichtigungen
Alles löschen
Operation
2
Beiträge
2
Benutzer
0
Reactions
4,378
Ansichten
Themenstarter
Can my Stepcraft2 840 be run in Inch mode (G20) rather than Metric mode (G21)?
Veröffentlicht : 25/06/2017 6:44 pm
Check the UCCNC user manual Section 4.1 to see if the G20 code is supported.
http://www.cncdrive.com/UCCNC/UCCNC_usersmanual.pdf
It jumps from G19 to G28 so it doesn't look like it. I noticed UCCNC telling me that G21 was unsupported recently so it might return an error message in any case.
Doug
Stepcraft 2/840, StoneyCNC industrial HF spindle, 4th axis, TurboCAD 2016 Professional 64 bit, MeshCAM, GWizard feeds & speeds calculator, UCCNC
Hobby use: guitar building (luthiery), https://dsgb.net
Veröffentlicht : 27/06/2017 6:55 am
