Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
4
Beiträge
4
Benutzer
0
Likes
4,975
Ansichten
Themenstarter
Hello everybody,
I would like to ask how far the end-mill must be inserted in the er-collet in order to operate smoothly. Since each endmill varies in length, is there a standard point where the mill must be inserted?
Alexandros
Veröffentlicht : 17/10/2016 3:15 pm
Rule of thumb is to support the milling cutter as much as possible into the collet.
You have to be careful to allow for height of clamps and job thickness.
Stepcraft 420 (version 1) - HXKJ-GS52-400W Air cooled DC spindle - 445nm Blue Laser diode G2
Veröffentlicht : 23/10/2016 11:09 pm
I just make sure the full length of the collet is full. I'm not doing anything aggressive however. Mostly Pine and Oak.
Stepcraft 2 420
500 Watt Spindle
3D Printing System
3d Probe
T-Slot Table
Tooling:
1/8" 60 Deg 4 Flute V Bit
1/8" 4-Flute Square Nose End Mill
1/8" 2 Flute Ball Nose End Mill
1/16" 2 Flute Ball Nose End Mill
UCCNC and VCarve Pro
Total Newbie!
Veröffentlicht : 24/11/2016 5:51 am
Rule of thumb is to support the milling cutter as much as possible into the collet.
You have to be careful to allow for height of clamps and job thickness.
Also it is not advisable to grip on the cutting flutes, so dont insert the cutter too far into the collet.
If you grip the cutting flutes and the cutter slips then you could damage your collet or cutter.
Veröffentlicht : 19/12/2016 7:03 pm
