Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
5
Beiträge
4
Benutzer
0
Likes
6,465
Ansichten
Hi.
I'm using the full version of the WinPC-NC (verry verry bad software btw).
I don't realize hot to use the tool length sensor with this software..
Any help ?
I see the sensor works ok in the signal test area of the winPC-nc..
but can't seem to see a button to learn and execute the lovering of the Z axis so that the program will understan the correct lowering.
I'm asking this because I'm little bit fed up with using the paper for Z height adjustment.
Veröffentlicht : 13/09/2015 8:20 pm
Check here these instructions: http://www.prototools.co.uk/shop/download/media/length_sensor/tool_length_sensor_LPT2.pdf
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Veröffentlicht : 13/09/2015 11:19 pm
These procedures doenst work for me too.I have 840 and tool lenght sensor with winpc-nc usb full,ı tried all adjustments in signals there is red light but no reaction when ı pressed sensor.is tehere any one solved this problem ?
Veröffentlicht : 12/03/2017 8:48 pm
@Bubbat:
I answered in the other thread as well.
The tool length sensor is connected to Pin 10 and not 15.
Pls. change this in your setup.
Additionally: in UCCNC you need a special Macro 31, maybe you need this in WinPCNc as well?
MfG
Roy
SC 600/2; SolidWorks; UCCnC und UC100; EstlCam und Arduino Steuerung; KRESS 800kfme;
Veröffentlicht : 12/03/2017 9:26 pm
hi DerRoy,in winpc-nc website says it support toollenght sensor with full usb.also I tried Pin 10 or inverse.but still nothing.I attached a photo of my parameters.how can I fix it ?thanks best regards
Veröffentlicht : 13/03/2017 1:20 am
