Benachrichtigungen
Alles löschen
Operation
5
Beiträge
4
Benutzer
0
Reactions
6,705
Ansichten
Hi.
I'm using the full version of the WinPC-NC (verry verry bad software btw).
I don't realize hot to use the tool length sensor with this software..
Any help ?
I see the sensor works ok in the signal test area of the winPC-nc..
but can't seem to see a button to learn and execute the lovering of the Z axis so that the program will understan the correct lowering.
I'm asking this because I'm little bit fed up with using the paper for Z height adjustment.
Veröffentlicht : 13/09/2015 7:20 pm
Check here these instructions: http://www.prototools.co.uk/shop/download/media/length_sensor/tool_length_sensor_LPT2.pdf
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Veröffentlicht : 13/09/2015 10:19 pm
These procedures doenst work for me too.I have 840 and tool lenght sensor with winpc-nc usb full,ı tried all adjustments in signals there is red light but no reaction when ı pressed sensor.is tehere any one solved this problem ?
Veröffentlicht : 12/03/2017 7:48 pm
@Bubbat:
I answered in the other thread as well.
The tool length sensor is connected to Pin 10 and not 15.
Pls. change this in your setup.
Additionally: in UCCNC you need a special Macro 31, maybe you need this in WinPCNc as well?
MfG
Roy
SC 600/2; SolidWorks; UCCnC und UC100; EstlCam und Arduino Steuerung; KRESS 800kfme;
Veröffentlicht : 12/03/2017 8:26 pm
hi DerRoy,in winpc-nc website says it support toollenght sensor with full usb.also I tried Pin 10 or inverse.but still nothing.I attached a photo of my parameters.how can I fix it ?thanks best regards
Veröffentlicht : 13/03/2017 12:20 am
