Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
4
Beiträge
3
Benutzer
0
Likes
4,433
Ansichten
Themenstarter
I have my S600 up and running now and I have built a small project to get me started with both CAD and Mach3.
It was a steep learning curve as I am sure most of you know. I am happy with what I have a aceived.
I do have 3 things where maybe someone could help.
1. When I start up Mach3, I often get "UNC100 not found"
I then have to re-start Mach3 numerous times after pushing and pulling on the USB wire/connecters. I have just fitted a new USB cable which seems to help but I obviously wont know for a few days.
2. A couple of times I have had to stop the machine mid-programm . After this the Z refuses to move up. When I jog, it moves in the DRO window but does not move physically.
I then have to close the machine/software down and re-start.
3. Twice I have started a programm which goes to about the third line of Gcode: G49 and then stops. G49 is "cancel tool length offset" , which I must admit, means nothing to me.
Any ideas would be appreciated.
Thanks
David
Veröffentlicht : 24/06/2015 8:41 pm
You can have a UCC100 no found for a number of reasons.
IF there is any issue with the Micro USB then you can have connectivity issues. You need to be careful about managing cables. A good strategy is to use an LPT cable -plug this into the machine and plug the UC100 into the cable. make sure to be careful of the cables when moving the machine.
USB power hubs on PCs can do strange things. Make sure your not running any power save stuff.
it can also be the USB port on your PC itself not being the freshest.
External device like hoovers, pumps etc can cause noise spikes and can in some cause issues.. Its best to have the machine on its own plug at least.
Veröffentlicht : 25/06/2015 7:59 pm
Themenstarter
Thanks, I'll give the cable a try
Veröffentlicht : 25/06/2015 9:49 pm
Please check if you have a grounding problem. People on German forum had difficulties based on different potentials on the machines which you can resolve by grounding The Stepcraft (and other tools connected).
Frank
Steppcraft 600/2 + HF500 + SwitchBox + Laser + Schleppmesser
Absaugung und Vakuumtisch
an Mach3 oder UCCNC mit Taster für Z-Null und Werkzeuglänge
Veröffentlicht : 26/06/2015 12:53 am
